Garage Door Repair Services › Garage Door Spring Replacement

Garage Door Spring Replacement in Glendale, AZ

Springs do the actual lifting — your opener just triggers the movement. When a spring breaks, the door either won't open at all or becomes dangerous to operate manually. There are two types used in Glendale homes: torsion springs mounted on the shaft above the door, and extension springs running along the side tracks.

Call (928) 404-0934

When to Call

When You Need Garage Door Spring Replacement

You heard a loud bang from the garage and the door won't open
The door lifts a few inches then drops back down on its own
One side of the door rises higher than the other when opening
The opener motor runs but the door barely moves or strains visibly
You can see a gap or separation in the coil of the spring
The door feels extremely heavy when you try to lift it manually

How It Works

Our Process for Garage Door Spring Replacement

1

Measure the existing spring

We measure wire diameter, inside diameter, and length. Getting this wrong is the main reason replacement springs fail early or put strain on the opener.
2

Check the door's actual weight

Door weight determines the correct spring size. We verify this directly rather than guessing from the door dimensions alone.
3

Remove the broken spring safely

Torsion springs are under significant tension even when broken. We use winding bars and follow a specific sequence — this is not a safe DIY job.
4

Install correctly sized replacement spring

We install a spring rated for your door's actual weight. Undersized springs wear out fast and put extra load on the opener motor.
5

Test balance and tension

A properly balanced door should hold steady at about halfway open when disconnected from the opener. We confirm this before finishing.
6

Check cables and drums

When a spring breaks, cables sometimes slip off the drums. We inspect both and reseat anything that shifted during the break.

What's included

Measurement and sizing of the correct replacement spring for your door
Removal of the broken spring and safe disposal
Installation of the new spring with proper tension adjustment
Cable inspection and reseating if displaced during the spring break
Door balance test after installation is complete
Lubrication of the new spring and adjacent hardware

What's not included

Replacement of cables that are frayed or damaged — that's a separate repair with separate parts
Opener repairs if the motor was damaged running against a broken spring
Replacement of both springs if only one broke and the second is structurally sound — we'll note its condition and let you decide

Real Situations

Common Scenarios in Glendale

A homeowner in a 1990s Peoria Avenue-area tract home hears a bang early in the morning and finds the garage door stuck with the car inside.

We come out, confirm the torsion spring snapped, and measure the original spring from the remaining coil sections. Most of these homes used standard residential springs we carry on the truck, so same-day replacement is typical.

A homeowner has a heavier double-car door with two torsion springs and one has broken.

We replace both springs when they're the same age. If one broke from fatigue, the second is usually close behind. Running a two-spring system with mismatched wear causes uneven lift and early opener failure.

Someone bought a home in Glendale with extension springs on the sides and they've never been serviced.

We inspect the springs, cables, and safety cables that run through the extension springs. Older extension spring setups sometimes lack the safety cable entirely, which is a hazard if a spring snaps.

Glendale Context

Why this matters in Glendale

Glendale's summer heat accelerates metal fatigue in springs, especially in garages without climate control, which is most of them. Many homes built in the 1980s and 1990s across west Glendale still have their original springs. A 25-to-30-year-old spring is well past its typical cycle life and will break eventually — usually at an inconvenient time.

Straight Talk

About pricing & scope

Spring pricing varies based on door weight, spring type, and whether one or both need replacing. Heavier doors — solid wood, thick steel — require higher-cycle springs that cost more. If we find cable or drum damage when we're in there, we'll show you what we found and quote that separately before touching it.

What This Fixes